A Quick Guide to the iDekUSA Long Sleeve/Pant Dek™

1: Quikclik™ your Dual Long Sleeve/Pant Dek™ into place on your press. To do so, position the Long Sleeve/Pant Dek™ over the Quikclik™ plate. Line up the holes on the bottom of the Dek™ to match circular dowels of the Quikclik™ plate. When the Dek™ and plate are paired, push the Dek™ toward the press to lock it into place.



The Long Sleeve/Pant Dek™ is compatible with all models of the iDek heat press and can be used on both pedestals.






2: Set the amount of pressure desired by turning the height adjustment knob located on the underside of the pedestal. Move the upper heat Dek™ over the sleeve Dek(s)™. Bring the handle to the lowered position to test tension. Adjust accordingly. Raise the heating element and slide the arm away from the long sleeve Dek™.







3: Release the pressure off-set arm from its initial position below The Long Sleeve/Pant Dek™.






4: Pull the garment onto the Dek™ through the neck (For long sleeves), or the waist (For upper pant leg), or the ankle (For lower pant leg) leaving only the surface to be pressed on the Dek™*.



* Garments can be laid over top of the Dek™ if desired. iDek recommends utilizing the over/under loading feature available with its Deks™ for optimal pressing and no risk of ghosting or creasing from the other side of the garment.



5: Reposition the pressure
off-set arm to its initial position beneath the end of the Dek™. The roller allows for easy positioning, no matter what loading style used.





6: Line up and place your transfer on the garment(s). Most transfers will be pressed image down on the garment. A teflon sheet may be used with transfers meant to be pressed “image up.”







7: Slide the heating element into position and press the sleeve(s) or pant(s). Press according to manufacturer’s time and temperature guidelines.




When unloading, remember to release the pressure off-set arm if the over/under loading technique was used. If unused, (not recommended) then the pressure offset arm(s) were never released.